Next, we will look at how to troubleshoot error codes on LG washers. First, look at the screen. On the screen what did it say? It said there was an error. It said 1E, which is what I saw.
That means something happened that caused the error code. Stop here before touching any buttons, because this has to be fixed at its source. Otherwise, it will happen again.
Steps to Reset Your Washer
That being said, fixing this code won’t do you any good if there’s still junk in your system.
But then you thought to yourself (it’s so easy at times). The “dE” error could be as simple as a door not shutting correctly. And yes, you have seen that pop up on your own unit lately. That flashing code on the screen said the lid was open or blocked. Sure enough, you closed the door all the way. It was an easy fix for the current alert.
And, of course, it is the one you should of never do.
After dealing with the physical problem, then what? Now we’re on the reset. Time for that power cycle.
You pressed the Stop button. That stops whatever cycle is running right now. You unplugged it from the wall. You waited a few seconds. That’s so there’s no residual power left. This resets the machine’s internal control board. Then you plugged it back into the wall. Machine comes back to life.
You examined the inside of the drum afterwards. Sometimes mistakes leave a bit of water behind. Sometimes it’s detergent buildup. That stuff cause other problems.
That’s why you cleaned it off. You wiped down that rubber seal. You looked for any standing water on the bottom. Getting rid of all that stuff will stop further mistakes.
This makes it run smoothly.
It sounds like a lot of work. Who wants to wait seconds for anything? But it worked. It was a reset. Your washer is back up and running as it should be. Those pesky error code was gone. The screen was blank and now it’s good to go. No new parts required. No service tech required. It was a simple power cycle.
But in what order? Knowing that order helps. First, you get to know the code. Second, you address the physical problem. Third, you reset the power. Fourth, you inspect for any residue.
These steps cover most issues. That’s what you’ve learned the hard way. Not addressing the root problem doesn’t work. Resetting too fast doesn’t work. Being patient does pay here. It is an easy fix.
Codes freak most folks out. Big problem, they think. Major mechanical issue. It is simple more times than not. It is usually a power glitch or a stuck door. That’s what you find.
Your experience proves that point. The machine protects itself. It stops to avoid damage. Right response prolongs life. Stick to the basics. No messing with settings if you can help it. That is good enough.
It’s universal. That’s applicable to many appliances. LG washers are no exception. It is safe to unplug. Wait. Plug back in, and it works again. You checked that with yours too.
The DirectDrive system holds up well to resets. No need for software patches or any kind of firmware update. You just need to power cycle it. It is a clear winner.
They don’t manage their residue. The screen is what everyone concentrates on. Not the inside of the drum. Soap and water sits there. This results in errors and smells.
Cleaning the seal is critical. Wiping the glass also helps. Avoid repeating mistakes.
Washer runs quietly
There is no more error history.
You are confident performing maintenance.
These are results from simple steps.
Don’t make it complicated
Your washer returned to normal operation.
Resetting works.
Open up and look inside
It is routine. It happens every time.
It is reliable again.
Annoying errors are gone.
It’s worth it
LG washers are easy to reset. It’s about paying attention. To the codes flashing on screen. The obvious pull of a physical trigger. The quick break in the current flow. The re-establishment of communication. The removal of standing water.
Repeat this until the faults are cleared. Normal washing is restored. You can trust your machine again. It makes all the difference.
