If your controller ceases to cooperate, you’ll have to reset it as well. That’s because something might’ve been broken with the connection. It’s easy enough to do and doesn’t require any tools.
Step-by-step reset instructions
To reset your controllers, you must detach them first. The Joy-Con comes out of the rail first.
Then you find that button in the middle of the side. And then you press that button hard and it’ll delete the pairing information and unpair the controller from the system. And then you wait a second and release.
The device is free again.
Make sure you can see the ports on the bottom side. Press again just to be certain because if you didn’t do this you won’t be able to get past the reset.
It’s critical here that you detach the controller from the console first. If you’re careful about doing this process, you don’t make that mistake.
Then you slide the Joy-Con back into the rail and bam! Pairing happens and the console see it right away.
You can see the controller go offline on the screen and then come right back online when you reattach it to the rail. It is a simple, fast solution.
It’s not complicated. The whole thing doesn’t take a minute at all. There are no menus to look through. You just locate the button and hold it down firmly. You just unplug the controller. Then you plug it back in. Finally you reconnect it, and there: It works. And it works reliably.
Sometimes connections get sticky. Sometimes the controller believe it’s connected when it isn’t. That results in lag. Resetting the connection removes that condition. It makes it handshake from scratch. You’re back in control. You are back playing.
It’s also worth noting that resets are hardware based and do not require settings. Resets are hardware based.
That button sends out a signal that essentially breaks the bond. You slide it back in. It reestablishes the bond, and the system take over from there. It’s efficient and you don’t need to do anything else.
Easy. Simple. The fix is immediate, with no wait for a patch. It saves time. It reduces frustration. When technology fails, you want a fast fix, and this is one. It has an elegant design. It is easy to use.
And yes, it’s also a solution for both the Pro Controller and Joy-Cons. I mean, it’s just detaching them, pressing the button on the side, and then reattaching them and going from there.
If your controls is acting wonky, give it a shot. Try it before you do anything else. If it worked for the first issue, it will probably work for you too.
And sure enough, the linked profile name appeared on the screen. Technology had worked. Problem solved. No repair required. No support call needed. Just push the button and … yes, it was worth it.
Writing it down helps. Writing it down will help you remember. Because you detached first. And then you pressed the middle. Then you attached last. Those were the three steps.
Twice you tested it. The results were consistent. It worked every time.
The battery icons appeared. Everything looked normal. The Wi-Fi signal was strong. The console was ready. Time to start the game. It was done. The system is stable.
Actually, sometimes you should of just reset it. It is much more comfortabley than waiting for a repair. If you want a moddern way to fix things, this is better than any other method. The Joy-Cons is easy to use. Just make sure you can see the ports on bottom side. It works better than any other way. You can recieve the connection back real quick. It is different than what most people think. You just need to be carefull. If the controller is acting wonky, just do this. It works based off the button press. You just need to be careful about doing this process you don’t make that mistake. One more thing, the controllers sits in the rail. This makes it work. You’ll be livig your life without lag.
